Understanding Duty Cycle Before You Buy An Inverter Welder

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as welding machines.

Welding produces fume made up of fine particulates and gases, and the composition varies depending on the process, the filler material and any coatings on the base metal. Fume rises from the arc and, without adequate control, can build up in the breathing zone of anyone working nearby, which is why extraction is treated as a core part of workshop set-up rather than an optional extra.

For anyone starting out, talking through process, budget and set-up with people who deal with first-time buyers regularly is generally worth more than another hour of reading spec sheets, and that's exactly the sort of conversation the advice line at welding machines is there for.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.

A gas lens sits in place of the standard collet body and uses a fine mesh to straighten the shielding gas flow into a smoother, more laminar stream around the arc. This generally allows a longer stick-out from the cup without turbulence pulling in surrounding air, which is particularly useful when working in tighter joints or awkward positions where the torch needs to sit further back from the work.