What Goes Into A Handcrafted Helmet Shell

The liner deserves the same care. A removable, washable liner keeps the inside fresh, and following the maker's washing instructions protects both the padding and the stitching around it.

To compare our full face and open face ranges side by side, see helmet care guide.

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

Getting helmet sizing right starts with a proper head measurement, taken with a soft tape around the largest part of the head, just above the eyebrows and ears. That figure points to a starting size, but it is only a starting point, since head shape varies as much as head size.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.

Sun and heat are the two things to watch for. Leaving a helmet on a dashboard or in direct sun for long periods will dull and eventually crack leather trim, so a helmet bag or a shaded spot makes a real difference over the life of the helmet.